Request a subnet from SixXS¶
Creating a Feetz Image with Radvd¶
Make sure the following is selected:
[*] Show advanced options [*] Enable IPv6 support
Package selection ---> Standard packages ---> [*] radvd (router advertisement daemon)
I also advice to add the following for easier troubleshooting:
Advanced options ---> BusyBox options ---> IPv6 Options ---> [*] ping6 command Advanced options ---> BusyBox options ---> IPv6 Options ---> [*] traceroute6 command
‚Patching‘ Freetz-1.2 with Client config option¶
With the following commands executed before make you can have this enhancement included also:
cd ~/freetz-1.2/make/radvd/files/root/etc/default.radvd/ wget "/browser/trunk/make/radvd/files/root/etc/default.radvd/radvd.cfg?rev=9419&format=txt" -O radvd.cfg cd ~/freetz-1.2/make/radvd/files/root/etc/default.radvd/ wget "/browser/trunk/make/radvd/files/root/etc/default.radvd/radvd_conf?rev=9453&format=txt" -O radvd_conf cd ~/freetz-1.2/make/radvd/files/root/usr/lib/cgi-bin/ wget "/browser/trunk/make/radvd/files/root/usr/lib/cgi-bin/radvd.cgi?rev=9444&format=txt" -O radvd.cgi
Setup in Freetz web-interface¶
In the setup it is ‚sufficient‘ to just configure a /64 from your /48 you received from SixXS. E.g. you can pick the first possilbe /64 range 2001:aaaa:bbbb:0000::/64
Network range - 2001:aaaa:bbbb:0000:0000:0000:0000:0000 - 2001:aaaa:bbbb:0000:ffff:ffff:ffff:ffff
Note In below screenshot enhancement 1921 is included.
Not much to tell here. The output of ifconfig should show that it recieved an IPv6 address, starting with your configured subnet and ending with part of your MAC address in there.
There should also be a default IPv6 route pointing to the IPv6 gateway (the router).
netsh interface ipv6 install
netsh interface ipv6 show address
firt make sure you create a restore point.
- next use the following commands (note I used both commands without verifying correctly which one was needed):
netsh int ipv6 reset c:\ipv6_reset.log netsh interface isatap set state enabled